This is a tiny, stylish, fully adjustable camera mount for the Raspberry Pi Camera V1.3 (not included). It is made of black acrylic and allows four different angles of repose.

Assembly Instructions

1. Take the large plate, and place the camera module lens into the square hole, such that the screw holes on the camera module line up with the screw holes on the plate.

2. Use the 4 nuts and bolts to attach the camera module to the plate. Do not over tighten. The module board must be straight, not bowed, under the pressure of the screws.

3. Carefully using clippers or scissors, trim any excess from the screws.

4. Clips the second plate into one of the 4 sets of slots along the sides of the main plate. The set you choose determines the angle the camera rests at. The ribbon cable should be at the top of the assembly.

5. The camera's natural orientation is fixed to be with the cable at the bottom. You can flip it by using $raspistill -vf -o filename.jpg to correct the orientation.

Package Includes :

1 x Two-piece Raspberry Pi Camera Module Mount
4 x Mini plastic screws
4 x Plastic Hex nuts